Precor RBK 815 - Manual (Page 19)

Assembling the Exercise Bike
17
To install the upright support and prepare the cables for
connection to the console:
1.
Remove the tape holding the base unit data cable and the
heart rate sensor cable in place inside the upright support
channel.
2.
Proceed according to whether or not you are installing
Cardio Theater equipment on the console.
If ... Then ...
You are not installing Cardio Theater equipment
on the console
Skip to step 6.
You are installing Cardio Theater equipment on
the console Continue with
step 3.
3.
Attach the lower ends of the following cables to the inner
side of the jack panel:
y
Television cable
y
Power cable
4.
Slide the jack panel back into its bracket in the right side
cover.
5.
Using a piece of tape or a plastic tie, bind together the
upper ends of all cables.
6.
While your assistant holds the upright support in place
over the body assembly, thread the cable or cables
upward through the support. When you are finished, use a
piece of tape to secure the upper connectors of the cables
at the top of the support.