Panasonic EY6803 - Manual (Page 10)

- 10 -
GUIDELINE TABLE
• Select the torque for fastening screws with the clutch handle.
• Guide for the selection of torque
Depending on the job, adjustments are possible in five levels by approximately 1 Nm
(10 k
g
f-cm) increments.
Setting Torque
Guide Depending on Material
Concrete Block
(A) (B) (A) (B)
Fastening
Screws
1 Approximately 1.5 Nm (15 k g f-cm)
 Approximately .5 Nm (5 k g f-cm)
3 Approximately 3.4 Nm (35 k g f-cm)
4 Approximately 4.4 Nm (45 k g f-cm)
5 Approximately 5.4 Nm (55 k g f-cm)
Drilling
Holes (Drill Mark) Approximately 8.3 Nm (85 k g f-cm) Drilling holes in metal
(A) For fastening screws into plastic anchor which requires dia. 6.0 mm (1/4") prehole in the concrete.
(B) For directly fastening screws into concrete (like topcon) with dia. 3.5 mm (1/8") prehole.
NOTE: This is only a rough guide. Required torque is different depending on the
shape, material, and application of the screws.
Set according to the work environment of the site.
BATTERY PACK
(EY9201 is included with shipment. )
Model EY9201 EY9200 EY9106 EY9101 EY9001, EY9006
Battery voltage 1 V DC (1. V × 10 cells)
Storage battery Ni-MH Battery Ni-Cd Battery
Capacity 3.5 Ah 3.0 Ah .0 Ah 1.7 Ah 1. Ah
BATTERY CHARGER
Model EY0110
Rating See the rating plate on the bottom of the charger.
Weight 0.78 kg (1.7 lbs)
Charging time 55 minutes (EY9201)
NOTE:
• Do not charge “Y” type Ni-Cd battery packs.
• For applicable battery packs to this charger, see the label on the charger or the
latest general catalog.
EY6803(EU).indb 10 2006/04/10 9:41:36