Battery recycling, Battery charger – Panasonic EY6803 User Manual

Page 7

Advertising
background image

- 7 -

NOTE:

Use under extremely hot or

cold conditions will reduce

operating capacity per charge.

Battery Recycling

For environmental protection and

recycling of materials, be sure that it

is disposed of at an officially assigned

location, if there is one in your country.

Battery Charger

NOTE: Charge a new battery pack,

or a battery pack that has not

been used for a prolonged time,

for about 4 hours to bring the

battery up to full charge.

Battery charger (EY0110)

1. Plug the charger into the AC outlet.
NOTE: Sparks may be produced when

the plug is inserted into the AC

power supply, but this is not a

problem in terms of safety.

. Insert the battery pack firmly into

the charger.

Battery pack

Battery charger

To AC

outlet

3. During charging, the charging lamp

will be lit.

When charging is completed, an

internal electronic switch will

automatically be triggered to prevent

overcharging.

• Charging will not start if the

battery pack is warm (for example,

immediately after heavy-duty

operation).

The orange standby lamp will

be lit until the battery cools

down. Charging will then begin

automatically.

4. When charging is completed, the

charging lamp will start flashing

quickly in green color.

5. When in any of the conditions that

battery pack is too cool, or the

battery pack has not been used for

a long time, the charging lamp is lit.

In this case charging takes longer

to fully charge the battery pack,

than the standard charging time.

• If a fully charged battery pack is

inserted into the charger again,

the charging lamp lights up. After

several minutes, the charging

lamp may flash quickly to indicate

the charging is completed.

6. If the charging lamp does not light

immediately after the charger is

plugged in, or if after the standard

charging time the lamp does not go

off, consult an authorized dealer.

NOTE: • When charging a cool battery

pack (below 5°C (41°F)) in a

warm place, leave the battery

pack at the place and wait for

more than one hour to warm

up the battery to the level of

the ambient temperature.

Otherwise battery pack may

not be fully charged.

• Cool down the charger when

charging more than two

battery packs consecutively.

• Do not insert your fingers

into contact hole, when

holding charger or any other

occasions.

CAUTION:

To prevent the risk of fire or damage

to the battery charger.

• Do not use power source from

an engine generator.

• Do not cover vent holes on the

charger and the battery pack.

• Unplug the charger when not in

use.

EY6803(EU).indb 7

2006/04/10 9:41:32

Advertising