Panasonic AG-VP320 - Manual (Page 12)

12
Connections
1
Disconnect antenna or cable from TV and
connect to DECK.
Basic Connections
• If your TV has AUDIO and VIDEO IN terminals, connect them to DECK for higher
quality picture and sound.
• You can enjoy stereo sound even if your TV is not stereo by connecting a stereo amplifier
to DECK.
• Connect DECK and TV with an RF Coaxial Cable a (supplied) or an AV Cable b (not
supplied) as shown in the figure below.
IN FROM ANT.
OUT TO TV AUDIO
IN 1 OUT
DVD/VCR DECK
VHF/UHF
R
L
VIDEO VHF/
UHF
VIDEO
IN
AUDIO IN
R L
TV
AV CABLE (not supplied)
2
Connect DECK to TV with RF Coaxial Cable.
RF COAXIAL CABLE
(supplied)
a
b
DSS
Receiver
OUT
IN
IN
Note to CABLE system installer
This reminder is provided to call the CABLE system installer’s attention to Article 820-40 of the NEC
in USA (and to the Canadian Electrical Code in Canada) that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the grounding
system of the building, as close to the point of cable entry as practical.
OUT
IN
Antenna or Cable
Cable Box
or
When using “Nut type” RF coaxial cables, tighten with
fingers only. Overtightening may damage terminals.
■ ■ ■ ■ ■ DSS Receiver DECK TV ■ ■ ■ ■ ■ DECK TV ■ ■ ■ ■ ■ Cable Box DECK TV