Printronix SL5000r MP - Manual (Page 45)

RFRTAG
45
VERIFY;DF8;H;*DF8 = *;*\r\n*
END
~EXECUTE;SGTIN;FCNT3
~DF1;*313233343536373839414243*
~DF3;*3435363738*
~DF6;*3224115*
~DF7;*3132333*
~AF1;<DF2>
~AF2;<DF6>
~AF3;<DF7>
~AF4;<DF8>
~NORMAL
RFRTAG
Purpose To read the content of an RFID tag (embedded in a
smart label) into a dynamic field. This command cannot
be mixed with the RFREAD command.
Mode CREATE
Format RFRTAG[;UNLOCKn [;format]];size[;mem bank]
( Bit Field)+
STOP
RFRTAG Specifies the RFRTAG command, enter
RFRTAG;
size A decimal number specifying the overall
bit length of the RFID tag memory bank.
UNLOCK n[;format]
Optional parameter to unlock the data
block so it can be overwritten later. n is
the passcode. The acceptable values for
n are 1 to FFFFFFFF in hex, a 4 bytes
data. The value of n should be the same
passcode used for the LOCK option to
unlock the protected data block. When
the UNLOCKn option is used to unlock
any memory bank, which at the same is
programmed to read the tag, the
operation UNLOCKn will not unlock ACS
memory area. The passcode (n) can also