Using a new accessory, Teaching, Teach new transmitter – POLAR CS600 User Manual

Page 43: Teach new speed sensor, Teach new cadence sensor

Advertising
background image

software also allows you to make graphical comparisons with previous results. The Polar Fitness Test
results are downloaded automatically to the software when you download exercises using the Transfer
Data option.

1 0 . U S I N G A N E W A C C E S S O RY

Teaching

Your CS600 cycling computer has been synchronized, or “taught” to work together with the Polar
WearLink W.I.N.D. transmitter and to measure heart rate, speed and distance. In other words, your
cycling computer receives signals from your transmitter and speed sensor only, and enables
disturbance-free exercise in a group.

If you purchase a new transmitter, speed, cadence* or power* sensor as a separate accessory, they
have to be introduced to the cycling computer. This is called teaching and takes only a few seconds.

To prevent interference during a cycling event, make sure you perform the teaching process prior to the
event.

Teach New Transmitter

Wear the transmitter and make sure that you are not near (40 m/131 ft) other Polar WearLink W.I.N.D.
transmitters. In time mode, press OK. The cycling computer starts searching for the transmitter signal.

Once the new transmitter is identified,

New WearLink found, Teach new WearLink?

is displayed.

Select

Yes

to confirm teaching.

Completed!

and

Exercise displays updated

are displayed. Start exercise

recording by pressing OK.

Select

No

to cancel teaching.

Teach New Speed Sensor

Make sure that there are no other speed sensors or cycling computers nearby (40 m/131 ft). The
teaching procedure only takes a few seconds.

You can teach one Speed sensor for each bike setting.

Select

Settings > Bike > Bike1 > Speed > On/Off

Select

> On > Teach new sensor?

is displayed

Select

Yes

to confirm teaching >

Start test drive

is displayed. Rotate the wheel a few times to

activate the sensor. A flashing red light indicates that the sensor is activated.

Completed!

and

Exercise displays updated

are displayed. The cycling computer is now ready to receive

speed and distance data.

Select

No

to cancel teaching and the already earlier taught speed sensor is taken into use.

If you haven’t taught speed sensor to recognize a certain bike before, speed information will not be shown.

Select >

Off

and the display returns to the previous menu display.

To return to time mode, press and hold the BACK button.

Once the speed sensor is taught to recognize the cycling computer, it will do so even if the sensor has been
turned off. When the speed sensor is turned back on

Teach new sensor?

is displayed. Select

No

and

Exercise displays updated

appears. If

Yes

is selected, the monitor goes into teaching mode.

Teach New Cadence Sensor*

Select

Settings > Bike > Bike1 > Cadence > On/Off

Polar CS600 User Manual

43

Advertising