ParaBody 848 - Manual (Page 8)

STEP 6:
FIGURE 6
• SECURELY assemble the BASE (1) to the UPRIGHT (2) using one 1/2 X 3” BOLT (27), two 1/2” WASHERS (21) (slide front washer
INSIDE of tube), and one 1/2” LOCK NUT (22). See FIGURE 6.
• Insert one 3 X 2” END CAP (15) and one 2” SQ. END CAP (13) into the ends of the UPRIGHT (2) as shown in FIGURE 6.
• SECURELY assemble the CROSS BRACE (4) to the UPRIGHT (2) using two 3/8 X 2-3/4” BOLTS (25), two 3/8” WASHERS (19), and two
3/8” LOCK NUTS (20). See FIGURE 6.
8
27 1/2 X 3”
3/8 X 2-3/4” 25
21
20
19
22
21
1
15
13
4
2