Pentair Hydrel Fixture Housing 620001 - Manual (Page 8)

P/N 620001 8 Rev. A 1-18-06
Fixture Housing Entry Hub Repair Instructions.
STEP 7
1. If a bonding wire is connected to the bonding lug in the fixture housing cover this connection with a listed
potting compound, (Scotchcast 2134 or equivelant).
a. This will require the pool water level to be lowered and the potted area dried.
b. Allow 30 minutes prior to applying the epoxy putty; see item 2, below.
2. Completely cover the exposed entry hub with two parts of underwater epoxy putty, (supplied with this kit), to
at least 1/4 inch thickness.
a. Do not cover the anode block.
b. Allow the light fixture cord to move freely within the putty.
NOTE
Cord must move freely within the putty to allow the removal of the light fixture should it ever need repair or replacement.
hn-06-11-16-98
Do not cover anode
block with potting
compound.
Potting Compound
Figure 7.