Pride Mobility 1103 - Manual (Page 18)

18 Jazzy 1103
IV. COMFORT ADJUSTMENTS
FIGURE 5. Armrest Width
FIGURE 4. Seat Height
Adjustment
LOOSEN KNOB
TO MOVE ARMREST
HEX HEAD NUT
SEAT PEDESTAL
BASE
SEAT PEDESTAL
After you have had your Jazzy for an extended period of time, you may find the need to adjust the seat. There are
some adjustments you can make to increase your comfort, such as seat height and armrest angle. If your Jazzy
1103 was configured at your local Pride provider or service center, please consult your health care professional
before changing seat position, or making any other adjustments. Some of these adjustments may decrease your
Jazzy’s performance and safety by changing its center of gravity.
SEAT HEIGHT
You can change the seat height to one of three positions in 2.5 cm increments.
To change the seat height:
1. Remove the seat. See V, “Disassembly” in this manual.
2. Remove the shroud.
3. Use two 9/16-in. wrenches to loosen and remove the hex head nut and bolt. See figure 4.
4. Slide the seat pedestal up or down in the seat pedestal base.
5. Align the holes on the seat pedestal and the seat pedestal base.
6. Reinstall the hex head bolt and tighten.
ARMREST WIDTH ADJUSTMENT
To change the armrest width:
1. Locate the two knobs on the armrest receiver bracket. See figure 5.
2. Loosen the knobs; slide the armrests in or out for the desired width.
3. Retighten the knobs.