Pride Mobility 1103 - Manual (Page 20)

20 Jazzy 1103
IV. COMFORT ADJUSTMENTS
FIGURE 9. Footrest Adjustment
FOOTREST DEPTH ADJUSTMENT (BALL
DETENT PIN SHOWN)
FOOTREST HEIGHT ADJUSTMENT
FOOTREST ANGLE ADJUSTMENT
FOOTREST HEIGHT
The footrest height is easily adjusted to six different heights. See figure 9.
To raise or lower the footrest:
1. Remove the seat and the body shroud. See V, “Disassembly.”
2. Remove the two 7/16-in. bolts from the footrest.
3. Raise or lower the footrest to the desired height.
4. Reinstall the two 7/16-in. bolts into the footrest.
FOOTREST ANGLE
You can adjust the angle of the footrest with a 3/16-in. hex wrench. See figure 9.
To adjust the footrest angle:
1. Turn the setscrew clockwise to raise the front of the footrest.
2. Turn the setscrew counter clockwise to lower the front of the footrest.
FOOTREST DEPTH
The Jazzy 1103 uses a ball detent pin to fasten it to the power base. For your convenience, Pride also supplies a
hex head bolt and Nylock nut. You can use this bolt and nut instead of the ball detent pin, for a more permanent fit.
To adjust the footrest depth:
1. Remove the ball detent pin from the footrest bracket.
2. Move the footrest in or out to the desired depth.
3. Reinstall the ball detent pin or the hex head bolt and nut (tighten with two 7/16-in. wrenches).