Philips WV-NW484S - Manual (Page 20)

20
Before Starting Installation
The following procedures are for installing the camera on walls and ceilings.
Important
• The type of screws for the installation depend on the material at the location in which
you will install the bracket (included). However, do not use wood screws or nails.
Metal material: Use M6 or M5 bolts and nuts for mounting.
Concrete wall: Use M6 or M5 anchor bolts for mounting.
• Be sure that the arrow on the installation bracket is pointing upwards.
• A pull-out force in excess of 294 N {30 kgf} is required for each screw used in the
installation.
• Use sufficient reinforcement for installations on ceilings that are made of gypsum board
and are weak.
Fixing the bracket (accessory)
• Use the bracket to install the camera on a wall or ceiling that is provided with a hole for
passing the cable through or on exposed piping.
• Screws for fixing the bracket to a wall or ceiling are not provided. Choose screws in
accordance with the materials and structure of the installation location.
• Screws for fixing the camera to the bracket are provided with the camera.
(Recommended tightening torque M4 : 0.8 N·m {8 kgf·cm}
M5 : 1.5 N·m {15 kgf·cm}
M6 : 2.5 N·m {25 kgf·cm})