Panasonic SA-XR55 - Manual (Page 20)

20
R
Q
T
7994
Conne
ct
ions
Se
tti
ngs
Bas
ic O
p
er
at
io
n
s
O
p
er
at
io
n
s
Bef
o
re
use
Ref
er
ence
Sound quality/Sound field/Convenient functions
Making a recording
You can record to a tape deck connected to TAPE REC (OUT) or a DVD recorder connected to DVD RECORDER OUT.
See the recording unit’s operating instructions for details on how to prepare it for recording.
Note
• You cannot record a source connected through a digital terminal.
• When recording from a TV/STB, DVR, CD or DVD ensure the source is connected through the corresponding analog terminals and “ ANALOG ” input
is selected. (ápages 4, 5, 9, 10 and 13)
• With a tape deck, you can record any analog source except TAPE.
• With a DVD recorder, you can record any analog source except DVR.
• When you select DVD ANALOG 6CH mode, only sound from the front left and right channels is recorded.
Adjusting the subwoofer level
You can adjust the volume of the subwoofer while
listening to a source.
Sound can be distorted if you raise the volume while
the subwoofer level is high. Reduce the subwoofer
level if this occurs.
Select. • You can make fine settings by pressing [TEST] then adjusting
the output level. (ápage 13)
• You cannot adjust the subwoofer level if “DVD ANALOG 6CH”
is selected.
• Select “ SW --- ” to stop output.
Factory setting: SW 10
Muting
To mute the volume.
• “ MUTING IS ON ” scrolls on the display while the volume is
muted.
• Muting is canceled when the power is turned off.
n
To cancel: Press again
Multi-source re-master
This original feature boosts the frequencies of the
higher harmonics that are lost during recording due
to compression.
You can enjoy a full, more natural sound with this.
Select.
• Dolby Pro Logic , DTS NEO:6 and SFC are canceled when using multi-source re-master.
• If you make any settings in “Speakers combination settings”, “Surround back speaker
settings” or “Speaker settings” (ápages 12, 21) when using multi-source re-master, multi-
source re-master is canceled.
Multi-source re-master cannot be used in the following cases.
• When input signal is DTS 96/24, PCM with sampling frequencies of 192, 176.4, 96 or 88.2 kHz.
Dimmer
Dim the display for better viewing in a darkened
room.
n To cancel: Press again
á Refer to page 19 for adjusting the brightness of the display.
EFFECT 1: For fast tracks (pop and rock)
EFFECT 2: For tracks with a variety of tempos (jazz)
EFFECT 3: For slow tracks (classical)
EFFECT 4: For compressed audio signals
OFF:
The re-master processing is off (factory setting)
VOLUME INPUT SELECTOR
UP DOWN
ENTER
CANCEL
TUNE PRESET
SPEAKERS POWER A B BAND BI-AMP DUAL AMP
MULTI
CONTROL
PHONES
VCR 2
VIDEO IN AUDIO IN L R
INPUT SELECTOR
1 Select the source to be recorded.
2 Begin recording.
Follow your recording unit’s operating instructions.
3 Start the source to be recorded.
Follow your equipment’s operating instructions.
INPUT SELECTOR