POLAR CE3.7 - Manual (Page 41)

SMOOTH CE3.7 Elliptical 41
Visit us at : www.smoothfitness.com
COMPUTER OPERATION
COOL DOWN – Target pulse program
After completing the Target pulse and the TIME counts down to zero a one-minute COOL DOWN program starts. The TIME
display will display ‘COOL’ for 10 seconds. The resistance will return to level 1 as the time counts down from 1:00 (including the 10
seconds ‘COOL’ display time). and the distance and calories will continue to count from the main program.
You cannot use the “UP, DOWN, START, MODE“ buttons in the “COOL DOWN ” program.
Heart Rate Operation
The CE-3.7 comes with EKG hand pulse sensors which can be found on the handlebars. To operate pulse rate function, place the
palms of your hands over the sensors. It will take a few seconds for your pulse rate to be displayed on the console. To keep
monitoring, keep gripping the sensors, if the readings are intermittent you may not have full contact with the sensors or not enough
of your palm on the sensor. Remove your hand and place it over the sensor again.
Heart Rate Training
To maximize your results from training it is essential to monitor the intensity of your workout through your heart rate.
It is imperative that you accurately determine the target pulse rate within which to train in order that you may improve your fitness
at a safe, comfortable and sustainable level.
The following table on the next page is a rough guide to determine the level at which you should be exercising based upon your
maximum heart rate (MHR).
Metric (KM) to English (ML) conversion
The computer display can show both English and Metric information, if you want to change from the Metric to English, Please
follow the below procedure:
When the computer is in the POWER ON status. Press and hold the “STOP” button then press the “UP” button. The LCD will
display “km/h or mph” blinking, use UP or Down button to select between “km/h” and “mph”, then press ENTER button to confirm.