Panasonic DP-6530 - Manual (Page 132)

1
2
3
4
5
6
7
8
9
10
11
12
7-4
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
MAX
Slide Rail
A
B
1 Pull the tandem LCF out carefully until it comes to
a stop.
- Be careful not to touch the drawer slide rail.
2 Open some packages of paper, take out entire reams
of paper and set them aligned in tray
A
and tray
B
.
- When setting the paper, set the paper for
A
to the right
side, and set it for B to the left side. (The paper can be
set neatly if you pile it up gradually and alternately in trays
A and B .) Be sure that the center lever is not open (refer
to the labels attached in the tandem LCF ).
- Up to 2500 sheets of paper (20 lb Bond) can be set.
- Paper starts being fed from the elevator tray A at first,
and when it runs out of paper, the paper on tray B moves
to the position A .
- Set the paper so that it does not protrude beyond the line
of indication shown on the rear guide plate.
- Do not use creased, folded, wrinkled or damp sheets of
paper.
- Be careful not to touch the drawer slide rail.
3 Close the cover of the tandem LCF.
- Close the drawer completely. The elevator tray automatically
moves up to the paper feeding position.
Be careful not to let your fingers be caught when closing the
drawer.
2. ADD PAPER SYMBOL (Cont.)
Adding Paper to the Tandem LCF (Large Capacity Feeder)