Philips VR675CG - Manual (Page 13)

11
Channel number or frequency display
You can switch between the display for ’channel number’ or
’frequency’ for manual channel search.
1 Press the AUTOINSTALL button.
2 Select and confirm ’CHANNEL/FREQUENCY’ .
3 Select and confirm ’CHANNEL’ or ’FREQUENCY’ .
Manual channel search
In certain cases the Automatic Channel Search may not be
able to find all of the TV channels (e.g.: coded TV channels).
You can then use this manual method to set the channels.
1 Switch on the TV set. Press the AUTOINSTALL button on
the video recorder.
2 Select and confirm ’MANUAL SEARCH’ .
3 Hold the P q
button until you have found the right TV
channel. A changing channel number or frequency will
appear on the TV screen.
4 Confirm with the OK button.
5 Select and confirm the programme number that you wish
to allocate to this TV channel (e.g.: ’P 01’ ).
6 If you want to allocate more TV channels, repeat
steps
3 to 5 until all TV channels have been stored.
7 To end, press the STANDBY m
button.
Note: Channel number or frequency can also be entered
directly at step
3 , using the 0-9 buttons.
* To enter a special/hyperband channel, first enter the
channel digit ’9’. The indication changes from ’CH’ to
’CA’. For example, for special channel ’S 30’, enter ’9 30’.
* Allocating a decoder: If you want to allocate a
decoder, press the
INDEX E
button at step 3 until
’DEC’ appears in the display.
* This video recorder can receive HI-FI sound transmis-
sions in ’NICAM’. At step
3 , you can switch ’NICAM’
off or on with the SELECT button.
* If the picture or sound quality is poor, you might have
selected the wrong TV system. Press the
SYSTEM
button at step 3 to change the TV system.
Playback via the aerial cable
If you do not wish to use a scart cable, the aerial cable
which is already connected will act as the connection
between your TV set and the video recorder. Ensure that the
video recorder is connected to the mains supply.
1 Switch on your TV set and select the programme number
that you have earmarked for video playback. (see operat-
ing manual for your TV set).
2 Ensure that no cassette has been loaded. With the video
recorder switched to standby, hold the
SYSTEM but-
ton for a few seconds until a modulator frequency e.g.:
’G591’(UHF-channel 36) appears in the display. The video
recorder transmits a test picture.
3 Tune in the TV set in the UHF wave band until this picture
appears.
MODULATOR 591 G
------------------------
-/+ G/KgSELECT
ON/OFF gCL OK
4 Switch the video recorder to standby with the
STANDBY m
button.
If you have interrupted making standard settings as
described in Chapter 1, ’INSTALLATION’, turn to that
chapter to continue making the standard settings.