Philips DVD740VR/001 - Manual (Page 15)

15
English
Setting Up your DVD/VCR
8 Press the MENU button to exit.
Adding/Deleting Channels
1 Press the VCR button, then the MENU but-
ton.
2 Press the PLAY B or STOP C button to
select INITIAL, then press the FF g button.
3
Press the PLAY B or STOP C button to
select CH TUNING, then press the FF g
button.
4 Press the PLAY B or STOP C button to
select MANUAL, then press the FF g but-
ton.
5 Press the PLAY B or STOP C button to
select POSITION, then press the FF g but-
ton.
6 Press the PLAY B , STOP C button or
numerical key pads button to select your
desired position number, then press the FF
g
button.
7 Press the PLAY B or STOP C button to
select SKIP, then press the FF g button to
select [ON].
● To memorize the channel again, press the FF
g button. ON will change to OFF.
a will be displayed.
MANUAL
POSITION P08
CHANNEL 008
DECODER [OFF]
SKIP
[ON]
6 Press the PLAY B or STOP C button until
the channel move to another position num-
ber, then press the FF g button.
Channel Reprogramming
You can replace two channels.
1
Press the VCR button, then the MENU but-
ton.
2 Press the PLAY B or STOP C button to
select INITIAL, then press the FF g button.
3 Press the PLAY B or STOP C button to
select CH TUNING, then press the FF g
button.
4
Press the PLAY B or STOP C button to
select MOVE, then press the FF g button.
5 Press the PLAY B or STOP C button to
select your desired position number, then
press the FF g button.
● You cannot select a position number where “-
-” appears next to the number.This is because
SKIP is set to [ON] for this position number.
7
Press the MENU button.
a will be displayed.
MOVE
P01: 01 P06: 06
P02: 02 P07: 07
P03: [03] P08: 08
P04: 04 P09: 09
P05: 05 P10: 10
Position Number
Channel Number
a will be displayed.
MOVE
P01: 01 P06: 06
P02: 02 P07: 07
P03: 03 P08: 08
P04: 04 P09: 09
P05: 05 P10: [10]