Philips WP3812 - Manual (Page 11)

 Push the water selection unit firmly onto the tap from below and
tighten the 4 screws evenly. Make sure that you keep the tap in the
center of the screw fastener. At the same time maintain pressure
on the water purifier housing from below (Fig. 20).
 Screw the attachment nut firmly onto the water purifier
housing (Fig. 21).
Make sure the rubber washer is firmly pushed against the tap to prevent
water leakage.
Installing the filter cartridge
1 Make sure the tap is closed.
 Set the water selection lever to the unfiltered stream
position (Fig. 22).
 Tilt the filter cartridge 90° backwards and insert it into the water
purifier housing. (Fig. 23)
 Pull the cartridge upwards until it is in upright position. (Fig. 24)
5 Air trapped inside the filter cartridge affects the flow rate of the
filtered water. To avoid this, slightly open the tap and let water run
through the filter cartridge for 30 seconds after you install/replace
the filter cartridge. The slow stream of water helps to remove any
air trapped in the filter.
Using the appliance
1 Make sure that the water purifier housing and the filter cartridge
are properly installed.
 Turn the water selection lever to the desired setting (‘click’).
The water selection lever has 3 settings: filtered spray, unfiltered spray
and unfiltered stream. See the sections below.
 Open the tap.
Water comes out of the tap at the selected setting.
,
English 11