Philips WP3812 - Manual (Page 7)

Before daily use
To prevent quick clogging of the filter cartridge, let the water run at
the unfiltered setting for around 5 seconds before every use.
If the water is highly coloured or turbid due to work on your water
network, do not let the water run at the filtered setting until the
water is clear.
Let the water run at the filtered setting for 10 seconds before use
each day.
Let the water run at the filtered setting for 60 seconds before use if
you have not used the water purifier for more than two days.
If you have not used the water purifier for more than two weeks, let
the water run at the filtered setting for 2-3 minutes before use. If the
filter cartridge emits an unpleasant smell, replace it with a new one.
Water temperature
Do not let water hotter than 50°C run through the water purifier,
because this may damage the appliance.
Do not let the water purifier freeze.
applications
Only use the appliance to filter water that meets drinking water
standards at the point of use.
Do not block the filtered water outlet or connect other devices to it.
If the water pressure is very high, reduce the water flow of the tap to
prevent damage to the cartridge.
Keep the water purifier away from heat to avoid distortion or
breakage.
Do not tamper with the water purifier.
Do not remove the filter cartridge while you use the water purifier.
Do not use the water purifier without a filter cartridge.
Do not place the appliance near a window where it is exposed to
direct sunlight.
This appliance does not soften water.
Do not use filtered water in aquariums. Tap water, filtered or
unfiltered, can be harmful to fish.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
English