Panasonic CQ-R223W - Manual (Page 7)

M O D E
CQ-R223W DOLBY B NR
D IS P
TRACK
TUNE
REMOTE
LO UD
MONO MUTE
DISC SCAN REPEAT RANDOM
APM
B A N D
PW
R
VOL / P US H SE L
1 MTL NR 2 5 B•S 6 3 TPS REP 4 MUTE D IS P PW
R
E
N
G
L
I
S
H
2
Clock Setting
CQ-R223W
13
E
N
G
L
I
S
H
1
CQ-R223W
12
General
Power
Turn the key in the ignition until the accessory indicator lights.
Power on: Press [PWR].
Power off: Press [PWR] again.
ACC
ON
Volume level (0 to 40)
Volume
Turn the knob clockwise to increase volume,
and counterclockwise to decrease volume.
Mute
Press [MUTE] to mute the sound completely.
Press [MUTE] again to cancel.
Loudness (LOUD)
Press and hold for more than 2 seconds [MUTE]
(LOUD) to enhance bass and treble tones at low or
medium volume.
Press and hold for more than 2 seconds [MUTE]
(LOUD) again to cancel.
M O DE
CQ-R223W DOLBY B NR
D IS P
TRACK
TUNE
REMOTE
LO UD
MONO MUTE
DISC SCAN REPEAT RANDOM
APM
B A N D
PW
R
VOL / P US H SE L
1 MTL NR 2 5 B•S 6 3 TPS REP 4 D IS P
TRACK
TUNE
Audio Mode
(Bass/Treble/Balance/Fader) The 24-hour system is used for the clock.
q
Push [SEL] to select the audio mode.
Volume Bass Treble
Balance Fader
[] TUNE], [[ TUNE] (Hours, minutes)
w
Hours
w Press and hold [DISP] (clock) for more than 2
seconds.
Initial Time
q Press [DISP] (clock).
(Hours blink.)
e Press [] TUNE] or [[ TUNE].
(Hours set.)
Minutes
r Press [DISP] (clock).
(Minutes blink.)
t Press [] TUNE] or [[ TUNE].
(Minutes set.)
y Press [DISP] (clock).
Note: Press and hold [] TUNE] or [[ TUNE] to
change numbers rapidly.
Time Reset
Press and hold [DISP] (clock) for more than
2 seconds to activate the time setting mode to reset
the time.
Then, repeat steps
ቤ to ቧ.
(End.)
“AdJ” is displayed when the
clock is not adjusted.
Turn [VOL] (volume) clockwise or counterclockwise to
change each level.
Bass:
Adjustable range: –12 to + 12 dB (by 3 dB step)
Treble:
Adjustable range: –12 to +12 dB (by 3 dB step)
Balance:
Adjustable range:
1 to 15 (by 1 dB step)
Balance center
(default)
R (right speaker) or L (left speaker)
Fader:
Adjustable range:
1 to 15 (by 1 dB step)
Fader center
(default)
F (front speaker) or R (rear speaker)
Up
Down
push
Note: If no operation takes place for more than 5 seconds in
audio mode (2 seconds in volume mode), the display returns
to the regular mode.
[DISP] (display)
Mute indicator
Loudness indicator
default: 0 dB
default: 0 dB
Remote control sensor (REMOTE) ( ➡ page 20)