Panasonic AJ-HD150FE - Manual (Page 32)

– 32 –
Jog/shuttle
Jog mode
1
Push the search dial to the “in” position.
Be sure that the JOG lamp lights.
2
Rotate the search dial.
The dial’s clickstops are cleared, and the tape is played back at the speed (–1
×
to +1
×
normal speed) corresponding to the speed at which the dial is turned. When the dial
rotation is stopped, a still picture appears. The playback picture is noise-free.
3
To transfer from the jog mode to another mode, press the appropriate button.
Shuttle mode
1
Push the search dial to release it from the “in” position. The SHTL lamp lights, and the
unit goes into the shuttle mode.
• Immediately after the power has been turned on, rotate the search dial and set it to the
centre position.
2
Set the SHTL/SLOW switch to SHTL or SLOW.
3
Rotate the search dial.
When the SHTL/SLOW switch has been set to SHTL, the playback picture speed is
varied from 0 to ±32
×
normal speed depending on the position of the dial. The playback
picture speed can be switched to ±8.4
Ч,
±16
Ч
and ±32
×
normal speed with setting
menu No. 101 (SHTL MAX).
The dial’s centre position is a clickstop where a still picture appears as the playback
image. When the SHTL/SLOW switch has been set to SLOW, the playback picture
speed is varied from –4.1 to +4.1
×
normal speed depending on the position of the dial.
The maximum speed can be selected using the setup menu No. 308 (VAR FWD MAX)
and No. 309 (VAR REV MAX). However, noise appears at speeds other than –1 to +1
×
normal speed.
The dial’s centre position is a clickstop where a still picture appears as the playback
image. The playback picture is noise-free.
4
To transfer from the shuttle mode to another mode, press the STOP button or other
button.
<Note>
• When the unit leaves the factory, its operation is set up so that it will be transferred to the
shuttle or jog mode when the search dial is rotated. If it is inconvenient for operation to be
transferred to the variable-speed mode directly, it can also be transferred through the
search button.
Set setup menu No. 100 (SEARCH ENA) to KEY.