Philips AZ 1025 - Manual (Page 15)

MAINTENANCE
15
PRECAUTIONS AND SYSTEM MAINTENANCE
• Place the set on a hard, flat surface so that the system does
not tilt.
• Do not expose the set, CDs, batteries or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• Do not cover the set. Adequate ventilation with a minimum
gap of 15 cms between the ventilation holes and surrounding
surfaces is necessary to prevent heat build-up.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.
CD player and CD handling
• The lens of the CD player should never be touched.
• Sudden changes in the surrounding temperature can cause
condensation to form and the lens of your CD player to cloud
over. Playing a CD is then not possible. Do not attempt to clean
the lens but leave the set in a warm environment until the
moisture evaporates.
• Always shut the CD door to keep the CD compartment dust-
free. To clean, dust the compartment with a soft dry cloth.
• To take a CD out of its box, press the center spindle while
lifting the CD. Always pick up the CD by the edge and replace
the CD back in its box after use to avoid scratching and dust.
• To clean the CD, wipe in a straight line from the center
towards the edge using a soft, lint-free cloth. Do not use
cleaning agents as they may damage the disc.
• Never write on a CD or attach stickers to it.
Tape deck maintenance
To ensure a good recording and playback of the tape deck, clean
parts
A,B and C show in the diagram below, after approx. 50
hours of operation, or on average once a month. Use a cotton bud
slightly moistened with alcohol or a special head cleaning fluid to
clean both decks.
1. Open the cassette holder by pressing STOP•OPEN
9/.
2. Press PLAY 1 and clean the rubber pressure rollers C.
3. Press PAUSE
; and clean the magnetic heads A and also the
capstans B .
4. After cleaning, press STOP•OPEN 9/.
Note: Cleaning of the heads can also be done by playing a
cleaning cassette through once.
AZ 1025 /17 page 15
English
X
A A B C
XP AZ 1025/17 19-09-2000 13:02 Pagina 15