Paradyne ACCULINK 336x E1 - Manual (Page 82)

ACCULINK 336x E1 NTU
4-24 December 1996 3360-A2-GB20-20
4. From the Patterns Abort screen, press the desired
Function key to abort either All active test
patterns, active Send test patterns, or the active
Monitor (Mon) test pattern.
F1
Patterns: Abort
All
Send Mon
F2 F3
If you select All, the E1 NTU terminates all active
test patterns and displays the message Command
Complete. Skip Step 5.
NOTE
Be careful when selecting a specific
test pattern to abort. If you mistakenly
choose to abort a test pattern that is
not currently running, a Command
Complete message still displays and
the test pattern currently active still
runs. You can use the TStat branch of
the menu to view the test status to
determine if the abort was successful.
5. From the Abort screen, press the Function key that
corresponds to the network or port for which you
want to abort a test pattern. Use the scroll keys, if
necessary.
F1
Abort: Send or Mon
NET Prt1 Prt2
F2 F3
The E1 NTU terminates the selected test pattern
and displays the message Command Complete.
Lamp Test
Use the Lamp Test commands to start and stop a test of
the E1 NTU front panel LCD and LEDs.
Starting a Lamp Test
To start a Lamp test,
1. From the top-level menu screen, select Test.
2. From the Test screen, press the key until the
Lamp selection appears on the screen.
F1
Test:
Rlpbk Lpbk
Ptrns
F2 F3
3. From the Test screen, select Lamp.
F1
Test:
Lpbk
Ptrns Lamp
F2 F3
4. From the Lamp Test screen, select Start.
F1
Lamp Test:
Abort
Start
F2 F3