Panasonic TX-86PW200A - Manual (Page 16)

Picture Menu Operation
Colour temperature The Colour temperature control allows
you to change the White balance setting
between Standard, Warm and Cool.
Use the or buttons to switch between
settings.
P-NR The P-NR (Picture Noise Reduction)
system is designed to reduce picture
noise during poor quality reception
conditions. Pushing the left or right
buttons will change the setting between
Off, Strong, Weak and Auto.
Use the or buttons to switch between
settings.
Scan mode The Scan mode control allows you to
change the Picture refresh setting
between 75/883i, 100Hz and Progressive.
Use the or buttons to switch between
settings.
75/883i This mode gives a
faster refresh rate and
more lines than a
standard television.
100Hz 100Hz will give a
steady picture for most
signals.
Progressive Recommended when receiving NTSC signals.
NOTE: The scan mode function is not available when Picture in Picture
is being used.
Switching is also possible using the button on the remote control.
Normalisation N
Pressing the Normal ( ) Button on the remote control, when the Picture Menu is displayed will return all
picture settings to the factory preset levels. This is called “Normalisation”.
Normalisation will not occur if the Picture Menu is not displayed when the Normal (
) Button is pressed.
Notes:
We recommend that you set the Scan mode to Progressive when viewing a PAL 60 or NTSC transmission.
When viewing a PAL transmission (other than PAL 60) with the Scan mode set to Progressive, the screen will
flicker. This is not a fault.
The Multipip function will not operate when a Progressive signal is used.
P-NR Auto
Contrast
Brightness
Colour
Sharpness
Picture menu
Scan mode 75 / 833i
Colour Temperature
Contrast
Brightness
Colour
Sharpness
Picture menu
Scan mode 75 / 833i
Colour Temperature Standard
P-NR
Contrast
Brightness
Colour
Sharpness
Picture menu
Colour Temperature Standard
P-NR Auto