Manual tuning, Tuning menu manual tuning, Using the front panel – Panasonic TX-86PW200A User Manual
Page 30: Using the remote control, Tuning the television to a vcr
Tuning Menu
Manual Tuning
This Television has been factory tuned to all the major city channels. Use this tuning procedure only if you wish to
reset individual Programme Numbers. The television should be switched ON and the TV/AV Switch set to TV.
Using the Front Panel
1.
Push the
button repeatedly until the Tuning
Menu is reached.
2.
Push the or
Button to access the Tuning
Menu.
3.
Push the
button to access the Manual Tune.
4.
Push the
or
button to select the Manual
Tune.
5.
Push the
button to switch to “Change
Programme”.
6.
Use the or
buttons to select the
programme location number to tune.
7.
Push the
button to switch to “Search”.
8.
Push the or
Button to start the search.
9.
The television will automatically search for the
next broadcast signal. As each station is found
the search will stop. If you do not want this
station restart the search.
10.
Push the to store the selected station.
11.
Push the
button to return the television to
the Tuning Menu.
12.
To return the television to normal operation
push the
TV/AV
button on the remote control or
repeatedly push the
button until the volume
display appears.
Using the Remote Control
1.
Push the Set Up (
) button.
2.
Push the
or
button to select the
Tuning Menu.
3.
Push the
or button to access the Tuning
Menu.
4.
Push the
or
button to select the
Manual Tune.
5.
Push the
or button to access the Manual
Tune.
6.
Push the
or
button to select the
programme location number to tune.
7.
Push the
or button to start the search.
8.
The television will automatically search for the
next broadcast signal. As each station is found
the search will stop. If you do not want this
station restart the search.
9.
Push the
to store the selected station.
10.
Push the Set Up (
) button to return the
television to the Tuning menu.
11.
Push the
button to return the television to
normal operation.
Tuning the Television to a VCR
1.
Turn the VCR On and either start a known tape playing or set the VCR Test Signal, if fitted, to On
(refer to the VCR operating instructions).
2.
Repeat steps 2, 3 and 4 of the Manual tuning procedure above. The television will treat the VCR as if
it was a normal television broadcast station.
NOTES:
1.
The antenna lead must be connected to the VCR and the VCR RF-Out must be connected to the TV
RF-In. Please refer to page 37.
2.
The picture and sound quality are usually much better if the VCR is connected using the AV Terminals.
Please refer to page 37 or 38.
Manual tuning (Front panel)
- , + : Search
STR : To store
F : To exit
STR F -/\/ +//\ TV/AV
29
Note: Pushing the
button at any time will stop the Manual tuning and return you to normal viewing.