Panasonic TX-86PW200A - Manual (Page 6)

Panasonic
Getting Started
Connect the Aerial
The RF (Aerial) Input impedance of this television is 75
Ω
. If your aerial lead is 300
Ω
ribbon (two wires
separated by a flat plastic strip) you will require a 300
Ω
/75
Ω
Balun (not supplied) in order to connect your
aerial to the television.
Note:
For your safety any external aerial should be installed by a reputable qualified installer and should comply
with Australian Standard AS1417.1.
In New Zealand the installation should comply with International Standard IEC597-1.1.
Connect the Power Plug
The televisions are designed for the Australian Standard Mains Voltage of 240V 50Hz and the New Zealand
Standard Mains Voltage of 230V 50Hz.
NOTE:
If the television is not going to be used for an extended period, remove the power plug from the wall outlet.
Turn on the Television
Push the Power Switch to turn the television ON.
Sit back and enjoy your new Panasonic television.
Power Switch
S-VIDEO
VIDEO
L
AUDIO
R
AV5 IN AV2 IN COMPONENT MONITOR OUT
R P
B P
Y
MONO MONO
A V 4 I N COMPONENT
R P
B P
Y
MONO
A V 1 I N
Panasonic AVC Networks Australia Pty. Ltd.
Distributed in Australia by Panasonic Australia Pty. Ltd. Distributed in New Zealand by Panasonic NZ. Ltd. Auckland New Zealand
MODEL TX-86PW200A
CHASSIS GP1E
220 ~ 240V 50Hz 179W
PART No. TBM4A0154
DO NOT REMOVE THIS COVER. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED TECHNICIAN.
WARNING - DANGEROUS VOLTAGE INSIDE.