Paxar Monarch Sierra Sport2 - Manual (Page 28)

4-4 Troubleshooting
Error Description
757
Load Supplies Load supplies (supply length mismatch),
because the calibrated supply length
differs by plus or minus .25 inches from
the format. Press
A under x to clear the
error.
758
Check Supply Either the supply is not seen or the on-
demand sensor is broken. Press
A
under x to clear the error. Check for a
label jam, clear the supply path, or
reload supplies. This error may occur if
you remove a label too quickly in on-
demand mode. The printer does not
recalibrate after this error.
762
Low Battery Recharge the battery. Press A under x
to clear the error.
763
Remove Label Waiting to dispense label. Press A
under x to clear the error.
765
Check
Printhead The printhead has less than four bad
dots. The printer can shift bar code
fields to avoid bad dots. Press
A under
x to clear the error and continue printing.
768
Check
Printhead Printhead has more than 10 bad dots or
is not connected. Connect the printhead.
Press
A under x to clear the error.
791
Error Pending The printer has an error pending. Turn
off the printer. Wait 15 seconds and turn
it back on. Resend the packets.
If you see a System Error Vector ## on the display,
call Service for instructions. If you need to return the
printer to Paxar, use the original packaging (box and
packing material).