Using saw with 2 x 4 extensions – Porter-Cable 3807 User Manual
Page 13
13
TO O L STO R A G E
A clip is provided on the rear of the saw and provides a convenient
storage area for wrench (A) Fig. 35, as shown.
FASTENING THE SAW TO A W O R K B E N C H
Before operating the saw, make sure it is firmly mounted to a workbench
or other supporting surface. Four holes (A) Fig. 36, are provided for
fastening the saw to a supporting surface.
USING THE SAW ON SAW H O R S E S
Fig. 37 illustrates the saw placed for use on saw horses. Notches in the
front and rear of the mounting feet are designed to fit conveniently on saw
horses.
USING SAW WITH
2 X 4 EXTENSIONS
Fig. 38 illustrates the saw being
used with 2 x 4 extensions.
Note that notches in the front
and rear of the mounting feet
(K) are designed to fit and
fasten to the top of the two 2 x
4 s (P). The length of the two 2
x 4 s (P) can vary depending on
your preference. The distance
from the top of the 2 x 4 s (P) to
the saw table is 3
1
…
2
"
.
This
enables you to nail or fasten
s
tandard 2 x 4 s (R) to the 2 x
4 s (P), as shown. The top of
the 2 x 4 s (R) will then be in
alignment with the saw table,
providing support for long
workpieces. If desired, fence
extensions (S) made of 2 x 2 s
can be aligned with fence (T)
and bolted to 2 x 4 s (R).
Fig. 37
Fig. 38
T
R
S
K
P
K
P
P
R
S
P
Fig. 35
A
Fig. 36
A
A
A
A