Assembling dust elbow and dust bag, Moving table to the 0 degree cut-off position – Porter-Cable 3807 User Manual
Page 7
7
A S S E M B LY
W ARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MITER SAW TO THE POWER
SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ A N D
U N D E R S TOOD THE ENTIRE OWNER S MANUAL.
ASSEMBLING DUST ELBOW AND DUST BAG
1.
Insert smooth end of dust elbow (A) Fig. 10, into opening (B). The dust elbow (A) can be rotated as desired.
2.
Compress spring clips (C) Fig. 11, on dust bag (D) and clip dust bag onto end of elbow (A) as shown.
MOVING TABLE TO THE 0 DEGREE CUT-OFF POSITION
1.
Rotate locking knob (A) Fig. 12, counterclockwise to unlock. Depress lever (B) and rotate table (C) to the 0
degree straight cut-off position, release lever (B) and tighten locking knob (A).
2.
Fig. 13, illustrates the table (C) in the 0 degree straight cut-off position.
3.
For proper operation and adjustment of the table, refer to sections, ROTATING TABLE FOR MITER
CUTTING , ADJUSTING
CLAMPING
ACTION OF TABLE LOCKING MECHANISM
and
ADJUSTING
SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.
Fig. 10
A
Fig. 11
C
B
D
A
Fig. 12
A
B
Fig. 13
C
C