Barcode function – Panduit LS7 User Manual
Page 63
60
BARCODE FUNCTION
The barcode function enables barcodes to be printed as part of labels. Four different param-
et ers enable you to create custom barcodes .
The default settings are CODE 39 PROTOCOL, LARG E WIDTH , HUMAN READ-
ABLE set t o ON, and CHECK DIG . set t o OFF.
Barcodes must be entered accordi ng to the fol lowing rul es:
To use the barcode function:
1
Hold down
and press
.
☞
To change t he dat a or parameters of a barcode that has already been created,
positi on the cursor below t he barcode mark (
) bef ore holding down
and pressi ng
.
A l abel can onl y cont ain one barcode. If a barcode has al ready been entered
when
i s held down and
i s pressed, the error message “1 BAR
CODE / LABEL” wil l appear.
To quit the barcode function wit hout making any changes, hold down
Parameter
Settings
PROTOCOL
CODE 39
WIDTH (barcode width)
LARGE, SMALL
HUMAN READABLE
(numbers pri nted below bar-
code)
ON, OFF
CHECK DIG. (check digi t)
OFF, ON
Protocol
Number of digits (includ-
i ng check digits and start
and stop codes)
Characters that
can be used
Notes
CODE 39
4 through 22
Numbers, letters,
spaces, and
symbols –, $, /, +,
and %.
The as terisk (*)
i s not needed as
s tart and stop
codes.
Code
N
Barcode
Code
N
Barcode
Code
N
Barcode
Code