Troubleshooting, Problem possible cause solution – Philips SCD463 User Manual
Page 12
Problem
Possible cause
Solution
POWER light (A-6, B-9)
Unit not switched on.
Press On/Off button (A-1) or
does not light.
set On/Off switch (B-8) to ON.
AC power adapter (A-3, B-3)
Connect AC power adapter
not connected to the
(A-3, B-3) to the DC 9V —
—<
<+
+
DC 9V —
—<
<+
+ power supply
power supply jack (A-2, B-5).
jack (A-2, B-5).
AC power adapter (A-3, B-3)
Connect AC power adapter (A-3,
not connected to the power
B-3) to a wall outlet.
supply.
Batteries low.
Replace batteries.
POWER light (A-6, B-9)
Batteries low.
Replace batteries.
is blinking.
High pitched noise.
Units too close to each other.
Move parent unit away from baby
unit (at least 1 metre / 3 feet).
Volume set too high.
Turn VOLUME control (B-8)
upwards.
No sound on parent unit. Volume off or too low.
Turn VOLUME control (B-8) on
parent unit downwards.
Units out of range.
Move parent unit closer to baby
unit.
No connection
Parent unit out of range of
Move parent unit closer
between units.
tansmitted signal.
to baby unit.
Units are set to different
Set channel selection switches
channels.
(A-8, B-7) to the same
position on both units.
EN
Troubleshooting
12