Panasonic DMC-FZ5GN - Manual (Page 98)

Connecting to a PC or Printer
98
VQT0Q40
Connecting to a PictBridge-compliant Printer
By connecting the camera directly to a
printer supporting PictBridge via the USB
connection cable (supplied), you can select
the pictures to be printed or start printing
on the LCD monitor.
Set the print settings such as print quality
on the printer beforehand. (Read the printer
operating instructions.)
A: USB connection cable (supplied)
B: AC adaptor (DMW-CAC1; optional)
1 Turn the camera on and then set
[USB MODE] on the [SETUP]
menu to [PictBridge (PTP)]. (P95)
2 Turn on the printer.
3 Connect the camera to a printer
via the USB connection cable A
(supplied).
• Connect the USB connection cable with
the [ ] mark facing you.
• Hold the plug C to push into or pull out.
• It may take time to print some pictures.
Therefore, use a battery with sufficient
battery power (P13) or the AC adaptor
(DMW-CAC1; optional) when you connect
to a printer.
• If the remaining battery power becomes
low during communication, the power
indicator blinks and the alarm beeps. In
this case, stop the communication at
once.
• Disconnect the USB connection cable
after printing.
• Do not use any other USB connection
cables except the supplied one.
DC IN 8.4V
AV OUT/
DIGITAL
When the DPOF
Print is not set. Select [SINGLE
PICTURE]. (P99)
When the DPOF
Print is set. (P85) Select [DPOF
PICTURE]. (P100)
VQT0Q40ENG.book 98 ページ ２００５年２月１６日 水曜日 午後２時４７分