Radio – Panasonic CQ-5100U User Manual

Page 19

Advertising
background image

CQ-5100U

19

Sound skips due to
vibration.

Mounting angle is over 30˚.

a

Adjust mounting angle to less than 30˚.

Instable mounting.

a

Mount the unit securely with the mounting parts, referring to the
section on installation.

Much noise in FM stereo
and monaural broad-
casts.

Trouble

Station is too far, or signals are too weak.

a

Select other stations of higher signal level.

The radio antenna is not extended enough.

a

Extend fully the radio antenna.

Preset station is reset.

Battery cable is not correctly connected.

a

Connect the battery cable to the terminal that is always active.

Check point

❐ Radio

Disc is in the CD
compartment but no
sound is made, or disc is
ejected automatically.

Trouble

Disc is upside down.

a

Place disc in the correct direction with the label side up.

Sound skips, bad sound
quality. (e.g. caused by
noise)

• Disc is dirty.
• Disc has scratches.

a

Clean disc, referring to the section on “Notes on Discs”.

a

The unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a
disc which are incompatible one another. Refer to instructions for the
concerned devices for details.

• Disc is dirty.
• Disc has scratches.

a

Clean disc, referring to the section on “Notes on Discs”.

A disc that has data other than CD-DA type is loaded.

a

Discs that have CD-DA type data should be used.

a

The unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a
disc which are incompatible one another. Refer to instructions for the
concerned devices for details.

Check point

❐ CD

Advertising