Panasonic CF-30KTPAXxM - Manual (Page 49)

9-26
Assembly of Main PCB
Safety Working
Put the cable ina a U-shape into the
intermediate chassis aperture next
to the connector.
Do not pinch the cable out of
the USB PCB.
Safety Working
Attach the PET Sheet
0 ~ 1
0 ~ 1
1 ~ 2
Cable SATA Signal
Sheet wrap
Safety Working
* Notes:
1. Apply the load when attaching the parts. 20N ~ 30N (2 ~ 3Kgf)/cm2
Insert the connector
wrapped with the
sheet into the conn-
ector on the board.
Bend the cable avoiding the connector.
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
S2
S3
S3
Connect the LAN cable.
To prevent the
Part edge from
touching the
Card FPC.
To prevent the mounted parts
from touching the Steel Plate.
Insertion
PWB SHEET Attach.
Fold and attach the back side.
(Notes)
1. Apply the load when attaching the attaching parts. 20~30N (2~3Kgf)/cm2
2. Reusing the attaching parts is impossible.
MCH HEAT RUBBE Set
MCH INS SHEE Set
Fix with Screws in order of the rear number of No.
Ex.) Fix in order of 3 -1 to 3 -2.
0~0.5
0~2
CHASSIS