Panasonic CF-30KTPAXxM - Manual (Page 54)

9-31
Assembly of USB / Antenna PCB
SHEET Attach.
1. Insert and remove plug straight
2. Don't make covering damaged at the time of cable handling.
㸈
Connect Cable into the CN2
of EXT ANT PCB and process
the wire.
㸇䇭
Attach SHEET to Cable
㸉
Attach EXT ANT PCB to the Cabinet
and fix with Screw.
EXT ANT PCB Set
SCREW-1
Tighten
SCREW-2
Tighten
Cable
ANT CABLE SHEET Attach.
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
(Notes)
FPC Edge Standard
1 r1
ANT CABLE PLATE Set
SCREW Tighten
WHIP ANT CABLE
Insert the Cable plug.
CABLE (DFJS1055ZA)
Ensure the Flex tag
does not run over.
Fit to the groove.
Misalignment: 1 or less
Pass the Cable along the
intermediate chassis
concave and connect it to
the coaxial Connector.
Match to the edge.
Misalignment: 2 or less
SHEET Attach.
S2
54~56
S1
Torque of tightening screw :0.2 ± 0.02N·m( Ṑ2.0 ± 0.2kgf·cm)
Reusing the attaching parts is impossible
<Notes>
1Apply the load when attaching the attaching parts. 20
䱊30䰚䯴2䱊3Kgf䯵/cm2
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
Tighten
Screw
Connect Connect
USB SUB PCB USB Cable
㪪㫌㪹㫊㫋㫉㪸㫋㪼㩷㪼㫅㪻㩷㪽㪸㪺㪼㩷㪸㪻㪻㫀㫋㫀㫆㫅㪅
㪛㫀㪽㪽㪼㫉㪼㫅㪺㪼㩷㫃㪼㫊㫊㩷㫋㪿㪸㫅㩷㪈
㪚㪥㩷㪼㫅㪻㩷㪽㪸㪺㪼㩷㪸㪻㪻㫀㫋㫀㫆㫅㪅
㪛㫀㪽㪽㪼㫉㪼㫅㪺㪼㩷㫃㪼㫊㫊㩷㫋㪿㪸㫅㩷㪈
㪧㫆㫃㫐㫄㫀㪻㪼㩷㫋㪸㫇㪼㩷Paste
㪠㫅㫊㫌㫃㪸㫋㫀㫆㫅㩷㫎㫀㫋㪿㩷㪸㩷
㪾㪸㫊㫂㪼㫋㩷㩿㪺㪸㪹㫀㫅㪼㫋㪀
CD Edge Sheet