Panasonic KX-F580 - Manual (Page 49)

49
Error messages on the display
If the unit detects a problem, the following messages will appear on the display.
DISPLAY MESSAGE CAUSE AND REMEDY
There is something wrong with the unit.
Contact our service personnel (see page 58).
The document is not fed into the unit properly. Reinsert the document. If the
misfeeding occurs frequently, clean the document feeder rollers inside the unit
(see page 55). If the problem remains, adjust the feeder pressure (see page 54).
Memory (phone numbers, parameters, etc.) has been erased. Re-program.
A mechanical error occurred. Open the back lid and re-install the recording
paper (see page 9).
The receiving unit is busy or ran out of recording paper. Try again.
The unit ran out of recording paper. Install a new recording paper (see page 9).
A recording paper jam occurred. Clear the jammed paper (see page 52).
The other fax machine does not provide the polling function. Check with the
other party.
The document is jammed. Remove the jammed document (see page 53).
Attempted to transmit a document longer than 600 mm (23
5 /
8
"). Press the STOP
button and remove the document (see page 53).
Divide the document into two or more sheets and try again.
A transmission error occurred. Try again.
The unit is too hot. Let the unit cool down.
CALL SERVICE
CHECK DOCUMENT
CHECK MEMORY
MECHA ERROR
NO RESPONSE
OUT OF PAPER
PAPER JAMMED
REMOVE DOCUMENT
POLLING ERROR
TRANSMIT ERROR
UNIT OVERHEATED
The receiving unit is busy or ran out of receiving paper. Try again.
REDIAL TIME OUT
The handset and handset cradle have been removed when you connect the
power cord.
—When you want to use the handset and handset cradle, install the handset
cradle correctly (see page 8).
—When you do not use the handset and handset cradle, set the handset switch
to NO HANDSET (see page 43). Then, disconnect and connect the power
cord again.
CHECK CRADLE
CHECK COVER
The back lid is open. Close it.
Troubleshooting and Routine Care