Patton electronic 3088 - Manual (Page 26)

26
password: ******
> dsl clear errcntrs
> dsl show errcntrs
crc: 0
losw: 0
tx fifo full: 0
tx fifo empty: 0
tx fifo slip: 0
tx stuff: 0
rx fifo full: 0
rx fifo empty: 0
rx fifo slip: 0
> logout
exiting remote console
> dsl set loopback rdl
> dsl set pattern 511e
> dsl show testmode
ber status: in progress
errors: 42
time: 12
> dsl set pattern off
> dsl set loopback off
> logout
password:
4.4 ROCKETLINK PLUG ‘N’ PLAY
The RocketLink Plug ‘n’ Play feature allows ISPs, carriers and PTTs to
quickly upgrade the link speed for a customer without requiring a visit to
re-configure the Customer Premise (CP) Model 3088. This feature also
allows service providers to set up all of the configurations at the Central
Office (via the ForeFront AIS system) before installing the stand alone
units, saving time spent configuring or re-configuring DIP switches.
Note RocketLink Plug ‘n’ Play is only available when using a Fore-
Front Model 3096RC as the CO unit.
The RocketLink Plug ‘n’ Play feature allows the user to configure the DTE
rate (bandwidth allocation, see Switches S1-1 through S1-7) of the CP
unit via the
ForeFront Model 3096RC at the Central Office (CO). The
stand alone unit at the Customer Premise (CP) site will automatically
configure itself to the DTE rate (Bandwidth Allocation) defined at the
Model 3096RC. Other configuration parameters remain in the
default setting.