Panasonic AJ-D400 - Manual (Page 21)

– 21 –
Time Code-Related Section (2)
Ä HOLD button
The time data appearing on the counter display at the instant when this button is pressed is
held. (The time code generator will still continue to run.) When the button is pressed again,
the hold status is released. Use the button to ascertain the time at which a particular scene
was shot, for example.
Å
RESET button
This resets the time data on the counter display to “00:00:00:00”. When the TCG switch
É is
set to SET and this button is pressed, the time code or user’s bit can be reset to
“00:00:00:00” or “00 00 00 00”.
Æ DISPLAY switch
The time code, CTL or user’s bit is made to appear on the counter display depending on the
setting positions of this switch and the TCG switch
É .
UB: The user’s bit is displayed.
TC:
The time code is displayed.
CTL: CTL is displayed.
Ç
UP button, DOWN button
When setting the time code or user’s bit, these buttons increment or decrement by 1 the fig-
ure of the digit made to flash by the SHIFT/ITEM button
И .
И SHIFT/ITEM (digit advance) button
When setting the time code or user’s bit, this button is used to cause the digit which is to be
set to flash.
√
Controls and Their Functions