Panasonic AJ-D400 - Manual (Page 23)

– 23 –
Power Supply
Power can be supplied to the unit using a battery pack or AC power supply.
Using a battery pack
A
Panasonic,
B
Anton Bauer or
C
Sony batteries can be used for the battery pack.
Before using a battery pack, be sure to charge it completely using a battery charger.
Á
See the Handling Instructions for the battery pack and battery charger for a detailed explana-
tion of charging methods.
Using an Anton Bauer Battery Pack
1
Mount the battery pack.
Insert the battery pack in the direction of the arrow and then slide it into place.
2
When detaching the battery, hold down the detachment lever of the battery holder and slide
the battery pack in the direction of the arrow.
| Note {
The AJ-D400 supports the intelligent battery system and the ultra-light system.
Automatic detection can be performed for intelligent batteries with a remaining battery level
of 10% or more. At this time, the remaining battery level is displayed numerically (percent-
age display) inside the viewfinder. If the power is turned on with a remaining battery level of
10% or less, the voltage is displayed. Also, after intelligent battery detection, the remaining
battery level display indicates the level for the intelligent battery even if power is supplied
from an external source.
Power Supply Output Connector
Control Switch
Lever
Pack