Paxar TC6021OH - Manual (Page 12)

About the Handle
The printer is powered by a NiCad battery pack in the handle
(power module). A NiCad battery lasts approximately two
years with average daily use.
When you first receive the printer, you will need to fully charge
the handle.
You can charge the handle with a:
•
wall charger. ... or ...
•
power module charger.
Refer to "Specifications and Accessories" for ordering
information.
Charging Time
A full charge takes approximately 8 hours using the wall
charger; approximately 1 1/2 hours using the 6094 Power
Module Charger. Depending on which power charger you use,
it can take 1-5 hours.
CAUTION
Always keep a handle attached to the printer. Storing the
printer without a handle may erase or alter the memory.
Make sure you charge the handles for the time
recommended.
Operator’s Handbook
4