Precor M9.20 - Manual (Page 13)

page 13
12. Place two external star washers (F) onto two of the upper handrail clamp
bolts (B) and have your assistant help you place the handrail clamp into the
groove on the lift column. Align the upper handrail clamp with the mounting
holes on the lift column. See Diagram 4.
13. Insert the bolts (B) through the handrail clamp and into the lift column.
Tighten the bolts securely with the hex key (H) provided.
14. Carefully route the ribbon cable through the slot on the left-hand side of the
handrail clamp.
Note: Right and left are determined while standing to the rear of the
treadmill facing toward the hood.
15. If your hands are dirty, wash your hands before continuing to the next step.
This will help keep the electronic console display clean.
16. Hold the electronic console over the handrail clamp to attach the ribbon
cable connector into its receptacle. Align the tab on the ribbon cable
connector with its counterpart located on the receptacle and plug the
connector into the receptacle using your fingers as shown in Diagram 5.
The plastic flanges on the receptacle should clip onto the connector when
you plug it in. If, at a later date, you need to disengage the connector, push
the flanges off of the connector and use your fingers to pull the connector
away from its receptacle. Note that the connector is designed to engage in
one direction only.
Do not force the connection.
Install
upper
handrail
clamp Diagram 4
Handrail clamp
Lift column
Ribbon cable
INCLINE
CAUTION
Keep hands and clothing away from
bed, belt and rear roller when treadmill
is in operation. As with any power
drivern equipment, DO NOT allow
children and persons unfamiliar with
operation on or near this treadmill.
Always straddle belt when starting
the treadmill. Step onto belt only at
speeds 1mph and slower.
Diagram 5 Attach
cable to
display
Connector
Ribbon cable
Plastic flange on receptacle