Precor M9.20 - Manual (Page 8)

page 8
Unpacking the M9.20 or M9.20s Treadmill
The M9.20 or M9.20s treadmill is carefully tested and inspected before
shipment. Precor ships the unit in six pieces as listed below:
• running bed assembly
• lift column assembly
• electronic console display
• handrails
• lift column trim
• owner’s manual, limited warranty card, and hardware kit (The hardware kit
is shown in Diagram 1.)
CAUTION: This unit weighs over 160 pounds. To avoid injury and to
ensure the safety of the unit and yourself, get adequate assistance before
dropping the sidewalls of the box and sliding the running bed assembly
out of the box. Do not lift the running bed from the box.
Carefully unpack the pieces of the treadmill and lay them on the floor near the
location where you plan to use the treadmill. At this time, do not cut the cable
tie that runs through the elevation tube and the lift column. The elevation tube
is calibrated at the factory and the plastic cable tie prevents excessive
movement during shipment.