Precor M9.20 - Manual (Page 16)

page 16
23. Attach the lift column trim by following these steps. While performing these
steps, refer to Diagram 9 for further clarification.
a. Position the trim strip so that the notched end points up. See
Diagram 9.
b. Insert the base of the trim through the opening in the hood.
c. Raise the trim until the notched end of the trim touches the underside
of the upper handrail clamp. Be careful to maintain vertical alignment of
the trim with the lift column.
CAUTION: Make sure that the ribbon cable is situated in the trim’s
center slot before you take the next step. Cables crimped or
pinched due to inaccurate assembly may not be covered by the
limited warranty.
d. While maintaining alignment, attach the trim by pressing firmly against
the lift column until the hook and loop pads fasten securely to each
other.
24. If you need to move the treadmill, ask for assistance from one or more
persons. Roll the treadmill on its front wheels to the new location by lifting
the rear end of the unit.
CAUTION: Do not remove the 3-prong plug or otherwise bypass it
with an adapter in order to use a non-grounded outlet.
25. Plug the treadmill into a standard 120v household outlet. Make sure that no
other appliances use the same circuit as the treadmill.
26. Continue on to Checking the Alignment of the Running Belt on the following
page to complete the installation of the M9.20/s treadmill.
Diagram 9 Attach trim strip
to lift column
Notched end
of trim strip
Velcro strips
Trim strip
Ribbon cable
Lift column