Panasonic MC-UG773 - Manual (Page 11)

- 11 -
Voltaje Protector termal Extensión de cordón Herramientas
120 V c.a. (60 Hz) Si 9.1 m (30 pi) Si
Power Thermal Protector Cord Length Tools
120V AC (60 Hz) Yes 9.1 m (30 Ft.) Yes
Alimentation Protecteur thermique Longueur du cordon Accessoires
120 V c.a. (60 Hz) Oui 9.1 m (30 pi) Oui
FEATURE CHART
Diagrama de características
Tableau des caractéristiques
- 38 -
BEFORE REQUESTING SERVICE
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
WARNING
Electrical Shock or Personal Injury Hazard
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum
cleaner suddenly starting.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Vacuum cleaner 1. Unplugged at wall outlet. 1. Plug in firmly. Push ON-OFF
will not run. switch to ON.
2. ON-OFF switch not turned on. 2. Push ON-OFF switch to ON.
3. Tripped circuit breaker/blown 3. Reset circuit breaker or replace
fuse at household service panel. fuse.
4. Tripped thermal protector. 4. Unplug vacuum cleaner, wait thirty
(30) minutes, plug in and switch to
ON.
Poor job of dirt 1. Full or clogged dust bag. 1. Change dust bag.
pickup.
2. Broken belt. 2. Replace belt.
3. Clogged body or nozzle hose. 3. Clean body or nozzle hose area.
4. Body hose not inserted fully. 4. Insert body hose.
5. Worn agitator. 5. Replace agitator.
6. Hole in body or nozzle hose. 6. Replace body or nozzle hose.
7. Dust cover improperly installed. 7. Properly install dust cover.
8. Belt not installed on motor shaft. 8. Install belt on motor shaft.
Dust escapes 1. Bag improperly installed. 1. Properly install bag.
the dust bag.
2. Bag torn. 2. Replace bag.
Light will 1. Burned out light bulb. 1. Replace light bulb.
not work.
Bag holder does 1. Secondary filter improperly 1. Properly install secondary filter
not assemble installed
properly