Panduit PTR3E - Manual (Page 20)

5. If using roll labels (or tags), load the roll onto the Label Supply Spindle so that
the printing side of the labels faces upwards as it unwinds from the roll. Push
the roll all the way to the inside of the printer and push the Label Roll
Retainer snugly against the outside of the label roll.
6. If using fanfold labels set them on a flat surface behind the printer. Pass the
labels (printing side up) through the slot in the rear of the printer.
7. Make sure the labels are routed
under the Label Guide and
through the Sensor Assembly.
8. Open the Label Hold-Down by
squeezing the green tab and the
release tab together. The Label
Hold Down is spring loaded and
will open automatically when the
latch is disengaged. Feed the labels
under the Label Guide, under the
Label Hold Down, through the
Sensor Assembly and out the front
of the printer.
9. Inspect the label routing and verify that the path matches that illustrated in the
Label Loading diagram. Set the Adjustable Label Guide to keep the labels
against the inside of the printer.
10. Close the Label Hold-Down by pushing downward on the green tab until it
latches closed.
12
Section 2. Installation