Panduit PTR3E User Manual
Page 31
Print Speed Adjustment (DSW2-8)
. See page 27.
Mode Selection (DSW3-1 and DSW3-2)
. Selects the operating mode of the printer.
Batch/Continuous disables the label taken (dispense option) sensor.
Label Sensor Selection (DSW3-3)
. Enables or disables the Label Pitch Sensor. If
the Sensor is enabled, it will detect the edge of the label and position it
automatically. If it is disabled, the positioning must be under software control using
Line Feed commands for continuous media printing.
Back-Feed Selection (DSW3-4)
. When Back-Feed is enabled, the printer will
position the label for dispensing/cutting and retract it before printing the next
label. See page 38 for information on setting the amount of offset.
EXT Print Start Signal Selection (DSW3-5)
. Allows an external device to initiate
a label print.
Note: This switch must be in the ON position if an external device is used to control
the printer via the EXT connector.
23
Section 3. Configuration
DSW3-3
SETTING
OFF
Sensor Used
ON
Not Used
DSW3
DSW3-4
SETTING
OFF
Enabled
ON
Disabled
DSW3
DSW3-1 DSW3-2
SETTING
OFF
OFF
Continuous
OFF
ON
Tear Off
ON
OFF
Cutter
ON
ON
Dispenser
1 2 3 4 5 6 7 8
ON
OFF
DSW3
DSW3-5
SETTING
OFF
Disabled
ON
Enabled
1 2 3 4 5 6 7 8
ON
OFF
DSW3
ON
OFF
1 2 3 4 5 6 7 8
ON
OFF
1 2 3 4 5 6 7 8