Niles Audio IR-KIT - Manual (Page 5)

1. 12V DC Jack – Provides 12Volt DC power to
IR-CB2 via a regulated power supply.
2. IR Emitter Outputs – 3.5mm jacks provide output for
either single or dual low-level flashers.
3. 3-30V AC/DC Status – 3.5mm jack provides
system status to sensors/keypads via a 12V power
supply attached to a switched outlet on the system
receiver or a 12V trigger output.
4. 12V Output – When 12V DC is detected at the
status jack (#3) the 12V output jack will output
12V/200mA DC. This is useful for triggering external
devices and system automation.
5. Status/IR Confirmation LED – This LED performs
two functions: (1) it provides a visible indication of
system status via a green LED and (2) confirms the
reception of IR data via a blinking blue LED.
6. Emitter Hi/Low switch – Setting these switches to
the appropriate position allows you to connect
either a high-output flooding emitter (IR-E1HO)
or low-output emitter. There is one Hi/Low switch
for emitter port four and one Hi/Low switch for
emitter port five.
7. Sensor Inputs – Removable quick connect sensor
plug for connection of IR sensors to the system.
3