Niles Audio IR-KIT - Manual (Page 7)

5
INSTALLATION
1. Select an appropriate location for the IR-CB2.
2. Run all the necessary wiring to the IR-CB2. Label
the wires for future reference.
3. Plug the supplied 12V DC power supply into the
un-switched AC outlet.
4. Plug the 12V DC power supply connector into the
IR-CB2 socket marked POWER.
5. After verifying that the AC outlet works, unplug the
power supply connector.
6. Determine the mounting location for the IR-SMR.
7. Make sure the mounting surface is clean.
8. Remove the protective coating from the self-
adhesive tape and attach the IR-SMR to the
mounting surface.
9. Run the IR-SMR cable. Label the cable for future
reference.
10. Locate the IR Connecting Block Snap and
Lock Connectors and remove them if they are
plugged in.
11. Use a small flathead screwdriver or your thumb to
raise the locking
tabs, exposing the
holes on the
connectors.
12. Insert each wire into
the appropriate hole
and snap down the locking tabs. Figure 1
13. Insert the smooth side of the connector plug into
the smooth side of the IR Connecting Block socket.
14. Connect the IR-E1 Emitters to the emitter outputs.
15. Plug the 12V DC power supply connector into the
IR-CB2 socket marked POWER.
See installation diagram (page 6).
(White) (Yellow) (Black)
(Red)
Figure 1