Network Instruments WAN Probe Kit - Manual (Page 12)

6 WAN Probe Kit Quick Installation Diagrams
Serial T1 TAP Quick Installation Diagram
10/100
NIC
WAN
Card
A
Probe
Service
Running
Observer
Console
TCP/IP
LAN
B
A
2 Install the
Network
Instruments
Probe
software.
3 From the Observer
Console, the newly-
configured Probe will
now be available on
Observer’s Probe List.
Use the supplied
10/100 cable to
connect the Probe to a
TCP/IP LAN with an
Observer system
attached.
1 Install the interface cards,
drivers, and cabling.
POWER
DTE
DCE
MODE
A B
ACTIVE OUTPUT
TX RX TX RX
Splitter cable
patched between
DTE and DCE
CSU/DSU
DTE
INPUT
Serial
T1/E1
TAP
TX RX TX RX
Router
(DCE)