Network Instruments WAN Probe Kit - Manual (Page 43)

Running Observer Software with the WAN Probe 37
Check the alarms you wish to set, then click the Triggers tab to set the criteria by which
the alarms will be triggered:
Note that most WAN alarms can be set on the DTE or DCE side or both; note also that the
Committed Information Rate displayed is that which you set in Discover Network Names
mode. See “Setting the Committed Information Rate (CIR) for a DLCI” on page 30. The
Actions tab lets you define actions to launch if an alarm is triggered. You can log
messages, send email, or even send a pager alarm.