NISSAN 2009 Cube - Manual (Page 11)

iPOD
ா** BUTTON (if so equipped)
Press the iPOD ா button to play an iPodா connected to the outlet located on the lower
center of the instrument panel.
AUX BUTTON
Press the AUX button to change the band to either SAT1, SAT2 or SAT3 radio stations
(if so equipped) or to play a device connected to the auxiliary audio input jack.
EJECT BUTTON
Press the button to eject a CD loaded into the player.
SEEK/TRACK BUTTON
Ⅲ Press the SEEK/TRACK button to skip from one track to another on a CD. Each time
the button is pressed, the CD will advance or skip back one track.
Ⅲ Press the SEEK/TRACK button to scan quickly through each broadcasting station
while the radio is playing.
iPOD ா CONTROL BUTTONS
Press the iPod ா MENU , ENTER and BACK buttons to control an iPodா connected to
the audio system through the iPod ா connector on the lower center of the instrument
panel.
STATION AND CD SELECT BUTTONS
Ⅲ To store a station in a preset, first select the desired band using the FM-AM button
for FM1, FM2 and AM or the AUX button for SAT1, SAT2 and SAT3 (if so equipped).
After tuning to the desired FM, AM or XM
ா station, press and hold the desired station
select button for at least 2 seconds. When the preset indicator illuminates, a beep will
sound to indicate that memorization is complete.
Ⅲ To retrieve a previously set station, select the radio band where the preset was set,
then press the corresponding station select button.
SCAN-RPT BUTTON
Press the SCAN-RPT button to quickly scan through each broadcasting station. The
tuner will pause for 5 seconds on each broadcasting station.
AUDIO BUTTON
Press the AUDIO button to change the audio settings. Adjust the bass, treble, fade,
balance, Speed Sensitive Volume (SSV) and beep on/off by pressing the AUDIO
button until the desired mode appears in the display. Press the TUNE/FF-
REW/FOLDER button up or down to adjust to the desired level.
9